This article provides some guidelines on cleaning and disinfecting simulators and simulator equipment.
- ONLY solutions permitted to clean avionics screens, genuine or otherwise etc. should be used.
- Don’t spray cleaners directly onto the item.
- Don’t get moisture into any openings.
- Use caution when cleaning polycarbonate lenes covering the CGI (Computer Generated Instruments).
Frasca recommends practicing routine cleaning and disinfecting frequently touched surfaces (see list below).
Coronaviruses may remain viable for hours sometimes up to days on surfaces made from a variety of materials. Cleaning of visibly dirty surfaces followed by disinfection is a best practice measure for prevention of illnesses in a community setting.
- Cleaning refers to removing germs, dirt, and other impurities from surfaces. Cleaning does not kill germs, but it removes them. This lowers the numbers of germs and the risk of spreading infection.
- Disinfecting refers to using chemicals to kill germs on surfaces. Disinfection does not necessarily clean dirty surfaces or remove germs, but killing germs on a surface after cleaning can further lower the risk of spreading infection.
Recommended Cleaning Solutions
Cleaning and Disinfection
- Disinfecting should take place after each training session, or after maintenance has been performed on the simulator.
- Cleaning and disinfection should occur after any person suspected of being infected has used or worked in the immediate vicinity of the simulator, and is no longer present.
Equipment to be Cleaned (if applicable)
- Any surface that can be touched or affected by respiratory droplets
- Electronics Cabinet
- Cabinet Surfaces (Including computer doors)
- Maintenance Keyboard
- Maintenance Monitor
- KVM Switch
- IOS/Debrief Station/Observer Station
- Main Power Key Switch
- IOS Box
- Headsets (Frasca discourages the sharing of headsets)
- Monitor(s)(Touch screen and Non-Touch) *Use only a soft, lint-free cloth. Avoid abrasive cloths, towels, paper towels, or similar items.
- Keyboard and Mouse
- Wireless Devices used to connect to Remote IOS or RTD IOS
- Any other surfaces not covered in this list
Cleaning and Disinfecting Procedures
- Shutdown the Simulator.
- Wear disposable gloves when cleaning and disinfecting surfaces. Gloves should be discarded after each cleaning. If reusable gloves are used, those gloves should be dedicated for cleaning and disinfection of surfaces. Consult the manufacturer’s instructions for cleaning and disinfection products used. Wash your hands immediately after gloves they are removed.
- If surfaces are dirty, they should be cleaned using a detergent or soap and water prior to disinfection.
- For disinfection, diluted household bleach solutions, alcohol solutions with at least 70% alcohol, and most common EPA-registered household disinfectants should be effective.
- For soft (porous) surfaces such as carpeted floor, IOS seats, cockpit seats, and seat belts, remove visible contamination if present and clean with appropriate cleaners indicated for use on these surfaces.